Three questions. If the answer is no, we will say so before you spend anything — a machine that does not fit your elements is worth nothing to you.
The inside diameter of the open end — measure the hole, not the can.
A tube you can look down through. Not a flat panel in a frame.
Roughly — this changes the recommendation, not whether it fits.
Outside diameter is irrelevant. A Ø400 mm element with a Ø180 mm bore fits this machine.
A bore of 95 mm or 310 mm is usually a different machine, but not always. Send the two numbers and we will check against the plate and rod before you commit.
Bore sets whether the plate holds the element. Height sets whether the 600 mm rod clears it.
One photo with a tape across the opening removes any doubt about which dimension is which.
We would rather confirm the fit than sell a machine that ends up in the corner of the workshop.
Tell us what you service and the measurements you took. You get a straight yes or no on the fit, plus an FOB or CIF price within 12 hours.
Fields marked * are required.